Alderlea T5 Specifications download pdf (Page 14)

170314-20 ALT5

WARNING: Do not use grates or andirons to elevate the fuel. Burn directly on the  re

bricks. Replace broken or missing bricks. Failure to do so may create a hazardous

condition.

Restarting After Extended or Overnight Burns

1. Open door and rake hot embers towards the front of the heater. Add a couple of dry,

split logs on top of embers, close door.

2. Adjust air control to high (left position) and in just a few minutes, logs should begin

burning.

3. After wood has charred, reset air control to desired setting.

4. To achieve maximum  ring rate, set control to high (left position). Do not use this setting

other than for starting or preheating fresh fuel loads.

Proper Draft

1. Draft is the force which moves air from the appliance up through the chimney. The amount

of draft in your chimney depends on the length of the chimney, local geography, nearby

obstructions and other factors.

2. Too much draft may cause excessive temperatures in the appliance. An uncontrollable

burn or a glowing red stove part or chimney indicates excessive draft.

3. Inadequate draft may cause backpuffing into the room and plugging of the chimney.

Smoke leaking into the room through appliance and chimney connector joints indicates

inadequate draft.

Ash Removal

Whenever ashes get 76mm to 102mm inches deep in your  rebox, and when  re has burned

down and cooled, remove excess ashes. Leave an ash bed approximately (25 mm) deep

on the  rebox bottom to help maintain a hot charcoal bed.

Ash Chute Operation: Your Alderlea stove is equipped with an ash chute system to ease

removal of ash from the ash lip area. To use this system,  rst pull out the ash pan approxi-

mately 51mm, sweep the ash into the chute located to the right side of the ash lip, and close

the ash pan again.

Ash Cleanout System: The ash dump handle is located under the ash lip on the left hand

side. To operate ash dump, pull handle out 13mm and turn clockwise. This will unlock the

ash dump and allow it to open. Hold handle open while pulling ashes into the opening. Avoid

large embers as these still contain heat value. Release handle and push in to lock. Ensure

ash dump door is properly engaged. Fill the cavity with the remaining ash level with the

 rebox  oor. Pull out ashpan and discard ashes into metal container. Replace ashpan and

ensure it is seated properly.

DO NOT OVERFIRE THIS HEATER:

Attempts to achieve heat output rates that

exceed heater design speci cations can

result in permanent damage to the heater

and chimney.

Do not burn with ash dump door open.

Doing so will create a hazardous

condition. Always leave about 1" of ash

in  rebox when cleaning.

CAUTION:

Ashes are to be removed only when the

heater is cold.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Alderlea T5 Specifications Page 14

Comments to this Manuals

Related products and manuals for Fireplaces Alderlea T5