Alderlea T5 Specifications download pdf (Page 15)

170314-20 ALT5

Chimney connector pipe should be disconnected from stove to clean and inspect.

Only if this is not possible should you remove baffle assembly.

DO NOT OPERATE WITH BAFFLE ASSEMBLY OR INSULATION REMOVED.

Removal

Remove retaining pin located at the rear top of the  rebox, just below the

baffle. Lift baffle up and pull forward to disconnect from the supply tube. Tilt baffle

sideways to drop down and remove from  rebox. Inspect gasket between baffle

and supply tube. If necessary, replace with gasket SSER.1395 available from your

Paci c Energy dealer. Re-install baffle assembly in reverse order. The two side

pieces of insulation must be tight against the siderails.

Baffle Removal

Disposal of Ashes

Ashes should be placed in a metal container with a tight  tting lid. The closed container of

ashes should be placed outside on a non-combustible  oor or on the ground, well away

from all combustible materials, pending  nal disposal. If the ashes are disposed of by burial

in soil or otherwise locally dispersed, they should be retained in a closed container until all

cinders have thoroughly cooled. Other waste should not be placed in this container.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

No comments

Alderlea T5 Specifications Page 15